Difference between revisions of "Spoil Boards"
From PROBOTIX :: wiki
(Created page with "==Installing the Sensor== Use studs to help spoilboard replacement") |
|||
| Line 1: | Line 1: | ||
| − | ==Installing the | + | ==Making a NEw Spoil Board== |
| + | [[File:ALL SPOILS.dxf]] | ||
| + | |||
| + | |||
| + | ==Un-installing/Installing the Spoilboard== | ||
| + | It helps to use M5 studs to hold the t-nuts in during removal or reinstallation of the spoil board. You can cut the heads off of longer M5 screws, if you cannot find M5 studs. The studs will also work as alignment pins during reinstallation. | ||
[[File:Spoil_board_helper_studs.jpg|200px|thumb|left|Use studs to help spoilboard replacement]] | [[File:Spoil_board_helper_studs.jpg|200px|thumb|left|Use studs to help spoilboard replacement]] | ||
Revision as of 15:12, 18 January 2018
Making a NEw Spoil Board
Un-installing/Installing the Spoilboard
It helps to use M5 studs to hold the t-nuts in during removal or reinstallation of the spoil board. You can cut the heads off of longer M5 screws, if you cannot find M5 studs. The studs will also work as alignment pins during reinstallation.
