Difference between revisions of "Spoil Boards"
From PROBOTIX :: wiki
| Line 1: | Line 1: | ||
| − | ==Making a | + | ==Making a New Spoil Board== |
[[File:ALL SPOILS.dxf]] | [[File:ALL SPOILS.dxf]] | ||
Revision as of 15:12, 18 January 2018
Making a New Spoil Board
Un-installing/Installing the Spoilboard
It helps to use M5 studs to hold the t-nuts in during removal or reinstallation of the spoil board. You can cut the heads off of longer M5 screws, if you cannot find M5 studs. The studs will also work as alignment pins during reinstallation.
