Search found 14 matches

by sgano
Tue Aug 16, 2016 9:45 pm
Forum: Software
Topic: Rotary Axis Error: Joint 3 Following Error
Replies: 3
Views: 3332

Rotary Axis Error: Joint 3 Following Error

I get "Joint 3 Following Errors" on many occasions when moving the rotary axis. Sometimes it is when jogging it; other times this happens during the middle of a run when the cutter is not moving very fast. Any advice would be greatly appreciated! I suspect it has to do with the settings in...
by sgano
Sun Aug 07, 2016 10:05 pm
Forum: Projects
Topic: Wooden Waves
Replies: 6
Views: 4680

Re: Wooden Waves

Here is picture after rough cutting the bottom side:
IMG_6064.JPG
IMG_6064.JPG (1.85 MiB) Viewed 4679 times
by sgano
Sun Aug 07, 2016 10:03 pm
Forum: Projects
Topic: Wooden Waves
Replies: 6
Views: 4680

Wooden Waves

Tried out 2-sided machining and learned a lot!

wavefield_maple_2016_SEG.jpg
wavefield_maple_2016_SEG.jpg (3.65 MiB) Viewed 4680 times
by sgano
Tue Aug 02, 2016 9:58 pm
Forum: Software
Topic: rotary post processer
Replies: 7
Views: 5081

Re: rotary post processer

I found some additional information about the rotary axis being so slow while using LinuxCNC. It appears that the issue is that LinuxCNC strictly adheres to NIST standard (NIST RS274NGC) that requires rotational axis to have a feed rate in degrees per minute units while linear moves in inches per mi...

Go to advanced search