Page 1 of 1

Hello from Ca

Posted: Fri Oct 30, 2015 10:59 am
by ljcraft
Hey everyone, I'm an engineering tech on contract a Intel. I've been designing and making simple 1 axis fixtures internal development platforms. Now i'm delving into a 3 axis pick and place tool for a project. instead of building from scratch I'v decided to purchase a comet router and convert to a pick and place tool. I built a 4 axis cnc tool (2 Z axis) for Intel back in the early 90's, using aerotech hardware. It's been a while since I've done any cnc programming but look forward to using the linux cnc that ships with the Comet router.

Re: Hello from Ca

Posted: Fri Oct 30, 2015 11:28 am
by pete
Welcome and good choice on the machine I know you will love it