Page 1 of 1

Pleased

Posted: Wed Jul 06, 2016 9:21 pm
by Marvin
Hi I'm Marvin from northern Indiana.
I picked up my nebula machine from the factory two weeks ago. Brought it home to my 19 x 16 sealed room in the basement. It was easy to set up plug and play. I made a few things with it using Aspire. I'm very pleased with everything. To start out I just used a slow feed rate 30in p m. I didn't break any bits yet , screwed up once when I forgot to set the Z height.

Re: Pleased

Posted: Thu Jul 07, 2016 7:02 am
by pete
Welcome Marvin

Re: Pleased

Posted: Thu Jul 07, 2016 6:06 pm
by probotixmissy
Hi Marvin! Glad to have you. Happy you are pleased so far, don't worry the spoil board is 3/4" MDF you will accidentally crash into it (just hope your bit doesn't break - manual e-Stop and ESC key are your friends :D ) it happens to everyone from time to time.

Welcome to the forum and thank you for your business!