I just started using a router table to take the sharp edge off of my panels so that I can minimize hand-softening.
The issue is that I need a bit like this: http://www.ebay.de/itm/251578787954
but as you can see, they're not cheap.
The reason I need them that size is 1) the edge softening needs to be about 1/32" radius and 2) the bearing pilot needs to be able to fit into a narrow U-shaped area on many panels that is less than .4" wide.
Anyone know of a source of these type of bits in Canada or the USA? I'd even order from overseas if they were a little more affordable.
What other machines do you own
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest