Router Table bit

What other machines do you own
Tomlin
Posts: 13
Joined: Fri Aug 21, 2015 10:16 am

Router Table bit

Postby Tomlin » Thu Sep 03, 2015 7:21 am

Hey guys

I just started using a router table to take the sharp edge off of my panels so that I can minimize hand-softening.

The issue is that I need a bit like this: http://www.ebay.de/itm/251578787954
but as you can see, they're not cheap.

The reason I need them that size is 1) the edge softening needs to be about 1/32" radius and 2) the bearing pilot needs to be able to fit into a narrow U-shaped area on many panels that is less than .4" wide.

Anyone know of a source of these type of bits in Canada or the USA? I'd even order from overseas if they were a little more affordable.
Attachments
1mm deburr.JPG
1mm deburr.JPG (18.28 KiB) Viewed 5415 times
Eric Tomlin
Probotix V90 (old MDF Version)
Waycross, Ga.

Irritant
Posts: 1
Joined: Sun Feb 28, 2016 3:10 pm

Re: Router Table bit

Postby Irritant » Sun Feb 28, 2016 4:01 pm

Not a lot of replies?? Use a router bit for wood and aluminum, either a 45 or roundover.


Return to “Other Machines”

Who is online

Users browsing this forum: No registered users and 1 guest