Page 3 of 3

Re: Reviews, Gripes, ETC.

Posted: Sat Dec 12, 2015 7:31 am
by pearcrl
A few years ago the college I worked for purchased a Comet that we needed to be portable. Here is the video that describes what I did. After more than a year of moving the Comet by 'folding' it I never noticed any issues with accuracy or twisting.
https://www.youtube.com/watch?v=csZCRZE2A_A

Re: Reviews, Gripes, ETC.

Posted: Fri Dec 18, 2015 4:37 pm
by justallan17
Thanks for the video pearcrl.
I built a table in one of the utility rooms downstairs and have it all set-up and running.

Re: Reviews, Gripes, ETC.

Posted: Sat Dec 19, 2015 1:18 pm
by 4DThinker
Clever adaptation, Rick. Fortunately where I teach the doors are always plenty wide for our CNCs to roll through without tilting. Big roll-up garage doors or double doors in most cases.

4D