Drag knife users - have you ever cut fabric?

A place to talk about anything that doesn't fit anywhere else.
Posts: 18
Joined: Tue Oct 13, 2015 3:46 pm

Drag knife users - have you ever cut fabric?

Postby kjoiner » Thu Dec 10, 2015 11:35 am


I was curious if any users who own drag knives have ever cut fabric. We have an application where we make a small curtain type part out of 1680 denier ballistic nylon. It has a lot of holes in it and using a punch is slow. Laser cutting would be ideal, but a drag knife might work too. The biggest challenge I see is keeping the fabric in place while cutting so it doesn't stretch or squirm around. A good sharp utility blade will cut the fabric so it seems doable.



Return to “Open Talk”

Who is online

Users browsing this forum: No registered users and 2 guests