Brochure Display Holder to dispense informational flyers - you know - the type of thing that sits near the register in a store. This was a new project request - so here is what we came up with.
Designed in VCarve Pro and cut from Oak and Maple on the CNC Router. The Maple legs were glued and screwed to the back half of the shell - with mortise and tenons for alignment. The front & back halves of the shell were then glued together with alignment dowels to form a pocket - with enough room to hold about 200 informational flyers.
Laser Engraved branding was also included on the front face to help link the unit to the intended purpose. Apparently - general purpose holders tend to get “re-purposed” rather than re-filled. ;-]
Post your videos here
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest