Page 1 of 2

Touch Plate for Video Interactive

Posted: Sat Oct 24, 2015 12:37 pm
by tcreed
Touch sensor machined from three pieces of plastic, two HDPE pieces with a 1/4" edge beveled acrylic piece sandwiched between. A RGB LED strip is held in a groove to light up the edge when activated. The whole piece sits on pressure sensitive pads to sense when the attached artifact is touched which starts a chapter of the video. Other images to follow.

Re: Touch Plate for Video Interactive

Posted: Sat Oct 24, 2015 12:38 pm
by tcreed
Another Pic.

Re: Touch Plate for Video Interactive

Posted: Sat Oct 24, 2015 12:39 pm
by tcreed
Another pic

Re: Touch Plate for Video Interactive

Posted: Sat Oct 24, 2015 12:40 pm
by tcreed
Another

Re: Touch Plate for Video Interactive

Posted: Sat Oct 24, 2015 4:10 pm
by probotix
Awesome!

Re: Touch Plate for Video Interactive

Posted: Tue Dec 01, 2015 2:01 pm
by rayk2
For some reason I am not able to view the attached JPG's. I would love to see what you have done.

Re: Touch Plate for Video Interactive

Posted: Tue Dec 01, 2015 6:04 pm
by 4DThinker
I can't see any pics either.

I made a touch plate that lights up when the bit touches as well using one battery holder, a single 3V LED, alligator clip, and a scrap of aluminum bar. Works well. Once the light comes on I enter the value on the light/battery box rather than zero to touch off Z.

Touch Light2 4D.jpg
Touch Light2 4D.jpg (881.41 KiB) Viewed 6158 times

Re: Touch Plate for Video Interactive

Posted: Tue Dec 01, 2015 6:05 pm
by 4DThinker
Light on.

Touch Light 4D.jpg
Touch Light 4D.jpg (1.48 MiB) Viewed 6158 times


4D

Re: Touch Plate for Video Interactive

Posted: Mon Dec 07, 2015 9:50 am
by tcreed
I could see them when I first posted, but I can't see them now either.

Re: Touch Plate for Video Interactive

Posted: Mon Dec 07, 2015 9:58 am
by tcreed
See if this works.

IMG_2038.jpg
IMG_2038.jpg (975.04 KiB) Viewed 6041 times