I have T-nut inserts in my spoil board. so I 've made this clamps that are perfect for me, notice at as the screw is partially hidden in the hole what makes it perfect to avoid collisions with my homemade dust boot.
I use a T-nut and a screw at te tail of the clamp to level the it according to the material I'm about to cut.
If I need to clamp down a bigger material I only need to change the two screws for larger ones
Show off your handy work here
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 7 guests