Page 1 of 1

LSU plaque for a friend

Posted: Thu Jan 26, 2017 3:35 pm
by Troy Hill
Hey guys, my first project on here from this newby to the craft. It turned out better than I thought it would. Three tool paths and 3 different tools, and I didn't mess it up! :lol: It's a birthday present for a friend. I'm starting to figure this stuff out! I love it! :D

Re: LSU plaque for a friend

Posted: Thu Jan 26, 2017 4:32 pm
by pete
Looks good

Re: LSU plaque for a friend

Posted: Fri Jan 27, 2017 9:30 am
by Troy Hill
pete wrote:Looks good

Thank you Pete, and thanks for all of your help! :D

Re: LSU plaque for a friend

Posted: Fri Jan 27, 2017 12:09 pm
by politicaldog
Stain or Paint?

Re: LSU plaque for a friend

Posted: Fri Jan 27, 2017 9:20 pm
by Juan Hidrovo
Good job.

Looks very nice.

Re: LSU plaque for a friend

Posted: Sat Jan 28, 2017 7:08 am
by Troy Hill
politicaldog wrote:Stain or Paint?

I spray painted the engraving and sanded it off after it dried, leaving only the paint in the engraved parts. Then I stained it.

Re: LSU plaque for a friend

Posted: Sun Jan 29, 2017 8:35 am
by politicaldog
Your friend will be very happy. Looks Nice!