Help with VFD connections

Discuss Machine Mechanics Here
KenW
Posts: 43
Joined: Tue May 23, 2017 11:49 am

Help with VFD connections

Postby KenW » Sat Jun 17, 2017 6:34 pm

Hi Everyone,

Getting ready to put together my new Asteroid but I'm a bit confused with connections. The setup manual showed two possible configurations but not for the equipment that I have and I don't want to hook up the wrong wires.
VFD-connections.jpg
VFD-connections.jpg (51.61 KiB) Viewed 2049 times


This is the VFD that I received Simphoenix and the wire harness that has a red wire (24v), white wire (AI) and a black wire with 3 possible connection points. Any advice on where to connect the black wire?

Thanks
Ken

KenW
Posts: 43
Joined: Tue May 23, 2017 11:49 am

Re: Help with VFD connections

Postby KenW » Sun Jun 18, 2017 5:55 pm

Ok. So I figured out the connections because the correct page was not included in the start up manual.

My only question now is about the twisted pair of black wires that was to be connected to the unity controller, but since I have a spindle, it says that this connection isn't needed. Does that mean it won't be used at all? Just want to be sure I don't screw something up.
Thanks.
Ken

4DThinker
Posts: 254
Joined: Wed Oct 07, 2015 10:57 am
Contact:

Re: Help with VFD connections

Postby 4DThinker » Sun Jun 18, 2017 10:32 pm

I personally don't use a VFD, but you might check out this page on their wiki: http://www.probotix.com/wiki/index.php/VFD_Spindles

4D


Return to “Machine Mechanics”

Who is online

Users browsing this forum: No registered users and 1 guest