Super-PID Speed Controller

Discuss Machine Mechanics Here
Posts: 6
Joined: Wed Oct 07, 2015 12:32 pm
Location: Plymouth, MA

Super-PID Speed Controller

Postby rayk2 » Tue Jul 18, 2017 1:17 pm

I am interested to find anyone who has experience integrating the Super-PID with LinuxCNC. I have been considering the Super-PID for a while now but need a little advice - and assistance in the connections. Thanks. rayk2

Posts: 41
Joined: Thu Oct 15, 2015 11:38 pm

Re: Super-PID Speed Controller

Postby TLHarrell » Fri Sep 13, 2019 10:54 pm

I have one, but I have a much older Probotix controller (pre-Unity) which doesn't by default have a pin to use for it. Was looking into stealing two of the three relay pins to make it work, and using the third for a touch probe. Haven't gotten quite that far since I'm not all that good at setting up LinuxCNC. Anyway, the router I was using with it died, and I moved to a 1.5kW spindle. Now looking forward to doing the same, but connecting the PWM signal to a 0-10V DC output board to handle the output to control the spindle.

Return to “Machine Mechanics”

Who is online

Users browsing this forum: No registered users and 1 guest