CNC Controller problem

Discuss Machine Mechanics Here
Juan Hidrovo
Posts: 244
Joined: Sun Jan 17, 2016 8:33 pm

CNC Controller problem

Postby Juan Hidrovo » Sat Feb 17, 2018 5:23 pm

Hello.

today while cutting some parts the machine suddenly stops.
Noticed the light switch on the box was off but the switch was in on position.
A smell like burned plastic or transistor was present.
Unplugged everything and open the box.
Find that a part was broken.
I would like to know if have to order only the LPSX-1 Linear Power Supply Board or the 40VDC 10Amp Linear Power Supply.
The copper coil looks fine to me.
A picture of the piece thats fried and a blown fuse in this board.
Attachments
transistor de cnc.jpg
transistor de cnc.jpg (294.83 KiB) Viewed 1656 times
Last edited by Juan Hidrovo on Sat Feb 17, 2018 5:27 pm, edited 1 time in total.

Juan Hidrovo
Posts: 244
Joined: Sun Jan 17, 2016 8:33 pm

Re: CNC Controller problem

Postby Juan Hidrovo » Sat Feb 17, 2018 5:25 pm

Another picture.
Attachments
bobina de cobre cnc.jpg
bobina de cobre cnc.jpg (744.46 KiB) Viewed 1654 times

Juan Hidrovo
Posts: 244
Joined: Sun Jan 17, 2016 8:33 pm

Re: CNC Controller problem

Postby Juan Hidrovo » Sat Feb 17, 2018 9:42 pm

thank You Len.

Just order the part.


Return to “Machine Mechanics”

Who is online

Users browsing this forum: No registered users and 1 guest