Asteroid Table

Discuss Machine Mechanics Here
proflemoi
Posts: 28
Joined: Sun Sep 20, 2015 3:56 pm

Asteroid Table

Postby proflemoi » Wed Sep 23, 2015 5:46 pm

Hello All... I am wondering if any of you have put in T-Track in your Tabletop and then a spoiler board over that? If so I am wondering how you might have done that as the CNC machine will not quite make it to the edge of the table to cut the track... perhaps you took the table top off to do this? Thank you.

Return to “Machine Mechanics”

Who is online

Users browsing this forum: No registered users and 1 guest