Page 1 of 1

PROBE IS ALREADY TRIPPED IN G35.2 OR G38.3 MOVE

Posted: Sat Dec 12, 2015 8:23 pm
by dsotmoon
PROBE IS ALREADY TRIPPED IN G35.2 OR G38.3 MOVE

I thought I'd post this if anyone else ever runs into this problem. I hooked everything up today and I have the tool length sensor installed. I followed the instructions from the WIKI to touch off the tool length sensor first before I run the file, but when i did the tool wouldn't plunge and hit the tool length sensor, I got the message "PROBE IS ALREADY TRIPPED IN G35.2 OR G38.3 MOVE" and I freaked out!

I came in the house and fired off an email to probotix support, after I sent the email I remembered as I hooked up the machine, the parallel hook up for the sensor hit the frame of the computer, it just didn't seat well, but i thought it did. Anyway, I went back and tightened the connection and everything ran perfect from there.

I searched the interwebs and didn't find anything to help me, so I thought I'd post this here so if anyone else ever searched for the same problem it may help them.