Table?

Discuss Machine Mechanics Here
tyman00
Posts: 8
Joined: Thu Oct 15, 2015 3:29 pm

Re: Table?

Postby tyman00 » Thu Feb 11, 2016 1:37 pm

We used a Kreg Universal Bench with casters. We then used 2 sheets of 3/4 plywood for the top. Overall, I was really impressed. It isn't cheap, but it's sturdy and rolls very well.

https://www.kregtool.com/store/c42/univ ... ight-legs/

4DThinker
Posts: 265
Joined: Wed Oct 07, 2015 10:57 am
Contact:

Re: Table?

Postby 4DThinker » Thu Feb 11, 2016 1:57 pm

On facebook Probotix has shown a table they made of aluminum extrusions, and claimed they will have prices at the end of this week. Versions for every CNC but their smallest. I know the 2-screw corner brackets they use on their CNC frames can be rotated even when screwed down tight, so I'm not sure there is enough structure to keep their design from racking under the load of the CNC. Just not sure what they are using for corner connections.

https://www.facebook.com/probotix/

4D

Juan Hidrovo
Posts: 247
Joined: Sun Jan 17, 2016 8:33 pm

Re: Table?

Postby Juan Hidrovo » Fri Apr 22, 2016 10:58 pm

My set up 2 months ago, nothing fancy.
Definitely need a new spoil board :D .
BTW only spent like 120 buck.
4x4, 2x4, 3/4 inch mdf sheet (2 of them) replace the original spoil board because the firs table was not big enough to support the machine and the spoil board was little curved in the center.
But nothing happens to the machine frame. :shock:
Attachments
IMG_1778.jpg
IMG_1778.jpg (1.91 MiB) Viewed 2972 times

edison auto
Posts: 58
Joined: Thu Dec 31, 2015 11:56 am

Re: Table?

Postby edison auto » Sat Apr 23, 2016 3:04 am

Looks like it gets the job done for you


Return to “Machine Mechanics”

Who is online

Users browsing this forum: No registered users and 2 guests