Acrilic R2D2

[Juan Hidrovo]

As usual, need to finish the base with light.
1/4 acrilic sheet.
Profile cut DOC 0.0359 tapered ball nose 1/16

[KLWestfall]

Carved font or back? And what do you do the profile cut with? Bits, depths and speeds...

Thanks.

klw

[ProbotixLance]

I WANT ONE! Hahahaha I would match my watch if it had a blue light! That is really cool.

[Juan Hidrovo]

Hi KLWestfall.

Front carved.
Profile cut was 1/8 O flute bit,
40 inch/min 3 passes.

Thank You Lance.
Im going to try this week to get the led light (blue, jajaja).
If ger the light post a pict of the lamp.

[Juan Hidrovo]

Finally have the time to finish the R2D2.
Now matches your watch Lance

[popshot1190]

That's pretty good,,, I Sam wondering where you get LEDs and. Battery holder assembly? Thanks

[Juan Hidrovo]

Hi popshot1190.

I think can het them on ebay. Got mine at signs shop.