Probotix Nebula CNC Router
Purchased two (2) months ago. Less than 10 hours of Total Use. In like new mechanical and cosmetic condition.
It was an impulse buy and I’m just not using it as much as I thought I would.
Bought it with the following items from Probotix:
Probotix Nebula : $4,699
80mm Air Cooled Spindle w/ VFD : $800
Z-Touch-off Puck : $120
Threaded Insert Table Grid (some damage) : $150
Keyboard/Mouse/Monitor Arm : $120
12pc. ER-20 Collet Set : $50
Freight : $400
Total ~ $6,340
I will also include the Table/Stand and Craftsman Stool as pictured for free.
Houston, TX. Local Pick-up only.
I also bought the following End Mills that I can sell:
18-Pc CNC Signmaking Advanced Router Bit Collection, 1/4 Inch Shank (https://www.toolstoday.com/p-6231-18-pc ... shank.aspx)
10-Pc 3D, Signmaking, Lettering & Engraving CNC Router Bit Collection, 1/2 Inch Shank (https://www.toolstoday.com/p-6261-10-pc ... ds=AMS-138)
Majority of End Mills never used.
If you have any machines for sale
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 0 guests