Discuss Machine Mechanics Here
2 posts • Page 1 of 1
I am interested to find anyone who has experience integrating the Super-PID with LinuxCNC. I have been considering the Super-PID for a while now but need a little advice - and assistance in the connections. Thanks. rayk2
I have one, but I have a much older Probotix controller (pre-Unity) which doesn't by default have a pin to use for it. Was looking into stealing two of the three relay pins to make it work, and using the third for a touch probe. Haven't gotten quite that far since I'm not all that good at setting up LinuxCNC. Anyway, the router I was using with it died, and I moved to a 1.5kW spindle. Now looking forward to doing the same, but connecting the PWM signal to a 0-10V DC output board to handle the output to control the spindle.
Who is online
Users browsing this forum: No registered users and 0 guests