New configuration and zpuck

A place to talk about anything that doesn't fit anywhere else.
oldmanofgf
Posts: 4
Joined: Wed Oct 28, 2015 12:09 pm

New configuration and zpuck

Postby oldmanofgf » Wed Oct 18, 2017 12:08 pm

Installed the new configuration file and z puck today everything working great should have done this a long time ago
Should make thing easer recommend anyone that hasn’t done it to install the new configuration file it was easy had no problems
Glenn

4DThinker
Posts: 257
Joined: Wed Oct 07, 2015 10:57 am
Contact:

Re: New configuration and zpuck

Postby 4DThinker » Fri Oct 20, 2017 5:34 pm

I agree, Glenn. Many thanks to whomever wrote the new configurator. Many more thanks for the wiki pages and all the information posted there. A treasure trove of valuable information useful to far more than just those with Probotix CNCs.

4D

jkarnowski
Posts: 1
Joined: Thu Dec 03, 2015 12:26 pm

Re: New configuration and zpuck

Postby jkarnowski » Sun Dec 22, 2019 11:31 am

I have a 2014 Galaxy Asteroid machine that does not have a second parallel port on the unity controller. I need to wire up my new z-puck to my breakout board. I attached a jpg to illustrate my question.

Seeing the Probotix Wiki parallel port connector wiring, can I assume that I wire direct to the breakout board pins that are labeled the same? In other words, DB25 pin 15 to PBX-RF pin 15 / DB25 pin 13 to PBX-RF pin 13 / DB25 pins 24 and 25 to PBX-RF GND next to pin 10?
Attachments
Z-PUCK_CONNECTION.JPG
Illustration for Z-Puck Wiring Question
Z-PUCK_CONNECTION.JPG (57.26 KiB) Viewed 63 times


Return to “Open Talk”

Who is online

Users browsing this forum: No registered users and 2 guests