I recently moved my Nebula to a new location and I discovered that the Limits connector had snapped three wires. I couldn’t resolder them because the paddle connectors on the plug snapped off. I bought new 8 pin xlr connectors and I labeled the harness wires as best I could but I’m not confident that I have the sequence correct. I have the 8 pin diagram from the Wiki and I know which pin does what.
Do the wire pairs go in sequence i.e. the red X wire goes on pin 1 and the ground goes on pin 2. Does it matter if the ground goes in the proper sequence? I realize that pin 7 pairs up with the center pin 8.
Also is there a way test each wire to make sure I’m labeling the limits connection correctly?
Discuss Machine Mechanics Here
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 0 guests