If you have any machines for sale
1 post • Page 1 of 1
Asking $600 Located in Ohio. No Shipping
For Sale Jet JWSS-10LFR
This is a high end extremely accurate saw. Sold new well over $1000.00
All parts are included and saw works fine. 110v/220v. It is wired for 110V
Extra Parts are brand new FREUD 10” Bladed in box
and a 10” Dado Stack.
I am downsizing my workshop.
Part are easily available
https://www.toolpartsdirect.com/jet-jws ... 08770.html
The first big workshop purchase for most people is a tablesaw. Priced and sized between the large cabinet saws and small benchtop saws, a contractor-style saw is the logical choice for many. I surveyed several brands on the market, checking for flatness, runout, and whether the factory settings of the trunnions and motors were parallel to the miter-gauge slots in the tops. I also ripped and crosscut 8/4 white oak and hard maple to test the machines under load. All of the saws I tested performed well.
This hybrid Jet is a cross between the older style contractor’s saw and the heavier-duty standard cabinet saw. The saw is equipped with the same arbor and trunnions as the Jet contractor-style saw but with a new motor location and a great drive-belt system. The fence has a sight glass that is hard to read from some angles and a rubber thumbwheel for fine-tuning the fence setting.
Editor Test Results:
Table Flatness N/A
Parallel Test Miter slot to blade: 0.035 in.
Arbor Runout 0.003 in.
Manufacturer's Web Site http://www.jettools.com
Max Rip Capacity 33 in.
Dust Collection Collection tray cabinet base with 4-in.-dia. outlet
Horsepower 1-3/4 hp
Amps 12 amps
Table Size 21-1/4 in. x 27 in. x 20-3/4 in.
Blade Size 10 in.
Blade Tilt Left
Learn to not sweat the small stuff and life is much easier!
Who is online
Users browsing this forum: No registered users and 0 guests