Difference between revisions of "Unity-M2"
From PROBOTIX :: wiki
| Line 2: | Line 2: | ||
[[Category:Need Pictures]] | [[Category:Need Pictures]] | ||
Example LinuxCNC config: [[File: Unity-M2.zip]] | Example LinuxCNC config: [[File: Unity-M2.zip]] | ||
| + | |||
| + | == Pin-out == | ||
| + | {{ParallelPort | ||
| + | |1=5VDC Relay 1 | ||
| + | |2=X Step | ||
| + | |3=X Dir | ||
| + | |4=Y1 Step | ||
| + | |5=Y1 Dir | ||
| + | |6=Z Step | ||
| + | |7=Z Dir | ||
| + | |8=Y2 Step | ||
| + | |9=Y2 Dir | ||
| + | |10=X Limit | ||
| + | |11=Y1 Limit | ||
| + | |12=Y2 Limit | ||
| + | |13=Z Limit | ||
| + | |14=120VAC Relay | ||
| + | |15=E-stop | ||
| + | |16=5VDC AUX | ||
| + | |17=5VDC Relay 2 | ||
| + | }} | ||
Revision as of 12:50, 12 October 2018
Example LinuxCNC config: File:Unity-M2.zip
Pin-out
|
1) 5VDC Relay 1 | 10) X Limit |
| 2) X Step | 11) Y1 Limit | |
| 3) X Dir | 12) Y2 Limit | |
| 4) Y1 Step | 13) Z Limit | |
| 5) Y1 Dir | 14) 120VAC Relay | |
| 6) Z Step | 15) E-stop | |
| 7) Z Dir | 16) 5VDC AUX | |
| 8) Y2 Step | 17) 5VDC Relay 2 | |
| 9) Y2 Dir | 18-25) GND |