Actions

Difference between revisions of "PBX-USB"

From PROBOTIX :: wiki

Line 7: Line 7:
 
== Diagram: ==
 
== Diagram: ==
 
[[image:PBX-USB_diagram.jpg|600px]]
 
[[image:PBX-USB_diagram.jpg|600px]]
 +
 +
[[image:PBX-Header|thumb|250px|Figure 1: PBX Header]]
 +
[[image:I2C-Header.jpg|thumb|250px|Figure 2: I2C Header]]
 +
[[image:PENDANT_Header.jpg|thumb|250px|Figure 3: Pendant Header]]
  
 
----
 
----
 
:Notes:
 
:Notes:
 
::
 
::

Revision as of 10:48, 20 September 2013

PBX-USB

The PBX-USB is a USB interfaced CNC controller that was developed specifically to work with the CNC USB Motion Controller Software from www.planet-cnc.com. This Interface sports 4x 10 pin PBX-Header Connections for interfacing to our existing stepper motor drivers. It has an additional header for direct connection to our RBX-1 3 channel relay board. This software/hardware combination can be further expanded with jog key inputs and an I2C bus for nearly unlimited additional I/O. This will allow the development of jog pendants, digital readouts, and input/output cards for a variety of purposes. The software runs on Windows and replaces Mach3 or EMC2. It can even be run through a virtual machine on a Mac or Linux host.

www.planet-cnc.com

Diagram:

PBX-USB diagram.jpg

File:PBX-Header
Figure 1: PBX Header
Figure 2: I2C Header
Figure 3: Pendant Header

Notes: