Difference between revisions of "PBX-BB rev4.1"
From PROBOTIX :: wiki
(→Getting Started) |
(→Getting Started) |
||
| Line 37: | Line 37: | ||
# Use a port scanner to find the ip address of the BBB. | # Use a port scanner to find the ip address of the BBB. | ||
# Connect to the BBB using Putty. | # Connect to the BBB using Putty. | ||
| − | + | *#*: Username: linuxcnc | |
| − | + | *#*: Password: linuxcnc | |
# Launch LCNC by typing 'linuxcnc &' into the shell. | # Launch LCNC by typing 'linuxcnc &' into the shell. | ||
# Use WinSCP and Notepad++ to edit the config files. | # Use WinSCP and Notepad++ to edit the config files. | ||
Revision as of 08:34, 9 February 2014
Model: PBX-BB BeagleBone Breakout Board
Breakout Board Specs:
- BeagleBone or BeagleBone Black Compatible
- Screw Terminals or 5x PBX-Headers
- RF Isolated Inouts and Outputs
- 15 Outputs and 5 Inputs
- Integrated 5V/2A Logic Supply Regulator
- USB Powered BeagleBone
Description:
The PBX-BB is the new CNC breakout board for the BeagleBone. It works perfectly with Charles Steinkuehler's Beaglebone port of LinuxCNC. It features 15 total outputs and 5 inputs, all software mappable to whichever signals you need. The PBX-BB features the same RF isolation circuitry found on the popular PBX-RF, protecting the Beaglebones' sensitive 1.8V and 3.3V circuitry from potentially damaging noise and spikes that can come from high voltage stepper motor drives.
The PBX-BB has 5x PBX-Headers (Figure 1) for easy connections to our stepper drivers and relay boards. Additional signals are present on the screw terminals for driving up to 5 motors and 4 relays.
New on the PBX-BB is a 5V/2A switching regulator that accepts voltages up to 76VDC. The efficiency of a switching regulator reduces heat. The 5V rail is bussed out to the PBX-Headers just like our other breakout boards, allowing you to drive the logic supply of the drivers from a single power source.
Getting Started
- Burn the iso image to an 8GB Sandisk MicroSD Card using Win32DiskImager
- Install the MicroSD card, plug the BBB ethernet connector into your network and apply power. The first time the image boots, it can take up to 5 minutes.
- Use a port scanner to find the ip address of the BBB.
- Connect to the BBB using Putty.
- Username: linuxcnc
- Password: linuxcnc
- Launch LCNC by typing 'linuxcnc &' into the shell.
- Use WinSCP and Notepad++ to edit the config files.
Resources:
File:PBX-BB.configs.zip
[MachineKit Image]
BeagleBone
http://bb-lcnc.blogspot.com/2013/07/adding-homelimit-switches.html