Difference between revisions of "PBX-USB"
From PROBOTIX :: wiki
| Line 7: | Line 7: | ||
== Diagram: == | == Diagram: == | ||
[[image:PBX-USB_diagram.jpg|600px]] | [[image:PBX-USB_diagram.jpg|600px]] | ||
| + | |||
| + | [[image:PBX-Header|thumb|250px|Figure 1: PBX Header]] | ||
| + | [[image:I2C-Header.jpg|thumb|250px|Figure 2: I2C Header]] | ||
| + | [[image:PENDANT_Header.jpg|thumb|250px|Figure 3: Pendant Header]] | ||
---- | ---- | ||
:Notes: | :Notes: | ||
:: | :: | ||
Revision as of 10:48, 20 September 2013
The PBX-USB is a USB interfaced CNC controller that was developed specifically to work with the CNC USB Motion Controller Software from www.planet-cnc.com. This Interface sports 4x 10 pin PBX-Header Connections for interfacing to our existing stepper motor drivers. It has an additional header for direct connection to our RBX-1 3 channel relay board. This software/hardware combination can be further expanded with jog key inputs and an I2C bus for nearly unlimited additional I/O. This will allow the development of jog pendants, digital readouts, and input/output cards for a variety of purposes. The software runs on Windows and replaces Mach3 or EMC2. It can even be run through a virtual machine on a Mac or Linux host.
www.planet-cnc.com
Diagram:
File:PBX-Header
Figure 1: PBX Header
- Notes: