Revision as of 11:02, 6 December 2018

Huangyang VFD

Huanyang VFD Wiring Diagram

Huanyang VFD Manual

To change settings:

1. Press [PROGRAM]
2. Use arrow keys to change to program number your looking to change
3. Press [SET]
4. Use the arrow keys to change the value to appropriate value
5. Press [SET] to save the value

Setting needed for galaxy series machines:

• PD001 – Source of Run Command – 0
• PD002 – Source of Operating Frequency – 1
• PD014 - Acceleration - 3
• PD070 – Analog Input 0-10V – 0
• PD144 – Rated Motor Revolution – 3000

Displaying RPM instead of Hz:

Press the arrow over key until the Rott light is illuminated

Sunfar E300 VFD

Sunfar E300 VFD Wiring Diagram

Sunfar E300 VFD Manual

To change settings:

1. Press [SET]
2. Use arrow keys to change to program number your looking to change
3. Press [SET]
4. Use the arrow keys to change the value to appropriate value
5. Press [SET] to save the value
6. Press [ESC] to exit programming mode

Setting needed for galaxy series machines:

• F0.0 = 1 (for 0-10V Control) or 3 (for knob control)
• F0.2 = 1000 (for panel [RUN] button)
• F0.4= 400 (Spindle Frequency)
• F0.5 = 5.0 (Acceleration time)
• F0.12 = 400 (Basic Frequency)
• F0.13 = 220 (Volts)
• F1.3 = 400 (Max Frequency)
• F1.7=1
• F1.8=2
• F1.9=3

Sunfar E500 VFD

Sunfar E500 VFD Wiring Diagram

Sunfar E500 VFD Manual

To change settings:

1. Press [SET]
2. Use arrow keys to change to program number your looking to change
3. Press [SET]
4. Use the arrow keys to change the value to appropriate value
5. Press [SET] to save the value
6. Press [ESC] to exit programming mode

Setting needed for galaxy series machines:

• F0.0 = 1 (for 0-10V Control) or 3 (for knob control)
• F0.2 = 1001 (for panel [RUN] button)
• F0.4= 400 (Spindle Frequency)
• F0.5 = 5.0 (Acceleration time)
• F0.11 = 0 (Torque Boost)
• F0.12 = 400 (Basic Frequency)
• F0.13 = 220 (Volts)
• F1.00 = 0.4 (AI Lower Limit)
• F1.01 = 10 (AI Upper Limit)
• F1.03 = 0 (Min Freq)
• F1.04 = 400 (Max Freq)
• F1.08 = 11 (Terminal 1 Function)