Create the page "NEW LinuxCNC Configuration" on this wiki! See also the search results found.

• PBX-BB rev4.1
  ...6.html Charles Steinkuehler's Beaglebone port] of [http://www.linuxcnc.org LinuxCNC]. It features 15 total outputs and 5 inputs, all software mappable to which New on the PBX-BB is a 5V/2A switching regulator that accepts voltages up to 76
  4 KB (576 words) - 03:17, 18 November 2016
• Automatic Tool Length Sensor
  ...at a later date, you will need to start with the [[#Installation]] and [[#Configuration]] sections below. ...off of that sensor, will then continue with the cutting process using the new compensated tool length offset.
  9 KB (1,576 words) - 09:36, 22 January 2019
• Limit Switch Error
  ...n temporarily disable the hardware limits in the configuration using the [[LinuxCNC Configurator]]. This will use the switches for homing only. You may need to ...ill oxidize over time and will need to be cleaned or replaced. You can buy new replacement switches
  3 KB (450 words) - 15:19, 16 November 2018
• PCI Parallel Port Cards
  Copied from linuxcnc.org forum: https://forum.linuxcnc.org/18-computer/18917-faq-pci-parallel-port-cards ...extra IO very cheaply, or even enable a computer without a parport to run Linuxcnc.
  5 KB (807 words) - 02:53, 25 November 2019